The MRES7732 Severe Duty High Cycle End Truck suspends Knight’s RAD7510 Single Bridge. The End Truck’s Redundant Yoke design allows for the pivoting in the “X” and “Y” directions which creates freedom of movement.

Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of ±

The MRES7777 Adjustable Height End Truck suspends Knight’s RAD7510 dual bridges. End truck may be adjusted slightly lower or higher on one end of the runway to allow the load trolley in the bridge to automatically roll back to its home position.
Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ±

The MRES7903 Dual Bridge Low Profile End Truck suspends Knight’s RAD7510 dual bridges. The end trucks yoke design allows for the pivoting in the “X” and “Y” directions which creates freedom of movement.
Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of ± 30

The MRES7904 Single Bridge Low Profile End Truck suspends Knight’s RAD7510 single bridges. The end truck’s yoke design allows for the pivoting in the “X” and “Y” directions which creates freedom of movement. Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of ± 30

The MRES7718 Single or Dual Bridge End Truck suspends Knight’s RAD7510 single or dual bridges. The dual trolley design improves bridge travel performance on bridge spans by distributing the overall load across a wider stance.

Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of

The MRES7717 Dual Bridge End Truck suspends Knight’s RAD7510 dual bridges. Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of ± 30 ksi.

The MRES7728 Single Bridge End Truck suspends Knight’s RAD4110 or RAD7510 Single Bridge. The End Truck’s Yoke design allows for the pivoting in the “X” and “Y” directions which creates freedom of movement. Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of ± 30

Attaches to Knight’s RAD4110, RAD6110, and RAD7510 Aluminum Series Rail Systems. Knight’s MRMA4488 Filter/ Regulator Bracket Assembly controls the air flow to the workstation crane system.

Carries festooning or cable for Knight’s RAD4110, RAD6110, and RAD7510 Series Overhead Aluminum Rail Systems. Knight’s MRMA4494 travels on a tag line on the side of the rail system and uses the complete length of the rail, which results in zero stack-up lengths. Alternate the “U” bolts from inside to outside when installing festoon hose. This will allow for minimal stack-up lengths.

The MREA4018 End Truck Connector suspends Knight’s RAD4110 bridges with the use of a Knight trolley. Knight End Trucks are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of ± 30 ksi.