ERail Conductor Trolley
The EMRTA6196 Conductor Trolley travels inside of the red ERail and carries power to the electrical tools/fixtures on the rail system. It is combined with the Knight Load Trolley. Copper graphite shoes are used for energy and control voltages over 35 V.
The ERail Conductor Trolley comes with a protective cord clamp (EMRMA6172) to help prevent damage to the electrical cable. Cable available
I-Beam Hanger (2in-7in Flange)
Used for Direct Loads and suspends Knight’s ERAD4000, ERAD6000 or ERAD7000 Series Rail Systems. This hanger is for the non-electrified side of an ERail System.
When using the EMRHS6163 Hanger, structural steel can be run perpendicular or parallel to the Knight rail system.
Coated with an environmentally friendly corrosion protectant.
ERail Tube Style C-Channel Hanger
Used for Direct or Offset Loads and suspends Knight’s ERAD4000, ERAD6000 or ERAD7000 Rail Systems. When using the EMRHA6160 Hanger, structural steel can be run perpendicular or parallel to the Knight rail system.
Low Profile Load Trolley with Yoke
Knight’s EMRTA4195 Low Profile Load Trolley with Yoke suspends a load from the ERAD4000 Series Rail System. The trolley’s yoke design allows for pivoting in the “X” and “Y” directions which creates freedom of movement. It attaches to the ERail’s conductor trolley.
Low Profile Load Trolley
Knight’s EMRTA4194 Low Profile Load Trolley suspends a load from the ERAD4000 Series Rail System. It attaches to the ERail’s conductor trolley.
Load Trolley with Yoke
The EMRTA4192 Load Trolley with Yoke travels along a horizontal axis and suspends loads from the ERAD4000 Series rail system. The trolley’s yoke design allows for pivoting in the “X” and “Y” directions which creates freedom of movement. It attaches to the ERail’s conductor trolley.
Load Trolley
Knight Global’s EMRTA4190 Load Trolley transfers loads along the horizontal axis and suspends a load from The ERAD4000 Series Rail Systems. It attaches to the ERail’s conductor trolley.
ERail Servo Trolley
The EMRTA4176 Servo Trolley attaches to a Knight Servo Hoist and runs inside of the ERAD4000 Series Rail.
Power Feed Redundant End Cap Assembly
The EMRAS4179 Power Feed Redundant End Cap Assembly attaches to the end of Knight’s ERail and the ERAD4000 Series Rail. It is primarily used to prevent a load trolley from exiting the rail.
Redundant End Cap Assembly
Knight’s EMRAS4171 Redundant End Cap Assembly attaches to the end of Knight’s ERail and the ERAD4000 Series Rail. It prevents an end truck or load trolley from exiting the ERAD4000 series rail. It also prevents dust from getting inside of the ERail.