Cable Saddle with Velcro Straps
The MRMA4301 Cable Saddle with Velcro Straps supports the electric or pneumatic festooning for the overhead rail systems. The velcro straps allow for fast and easy installation of the electrical cables or pneumatic hoses.
Hoist Load Trolley with Yoke
Knight Global’s MRTA7724 transfers loads along the horizontal axis and suspends Knight pneumatic balancers, hoists and fixtures from Knight’s RAD7510 series overhead aluminum rail systems. Knight Load Trolleys are manufactured from commercial grade pickled and oiled hot rolled steel with a tensile strength of ± 49 ksi and a yield point of ± 30 ksi.
Extreme Low Profile Perpendicular Rigid Hanger
Used for Direct Loads Only, suspends Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems. When using Knight’s MRHS4500 Hanger, structural steel can only be run perpendicular to the Knight rail system.
Extreme Low Profile Parallel Rigid Hanger (4in-8in Flange)
Used for Direct Loads Only, suspends Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems. When using Knight’s MRHS4503 Hanger, structural steel can only be run parallel to the Knight rail system.
Short Stack I-Beam Hanger (Parallel to I-Beam) (7in-11in Flange)
Used for Direct or Offset Loads, suspends Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems. When using the MRHS40861 Hanger, structural steel must be run parallel to the Knight rail system.
Short Stack I-Beam Hanger (Parallel to I-Beam) (2in-7in Flange)
Used for Direct or Offset Loads, suspends Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems. When using the MRHS40821 Short Stack I-Beam Hanger, structural steel must be run parallel to the Knight rail system.
Short Stack I-Beam Hanger (Perpendicular to I-Beam) (7in-11in Flange)
Used for Direct or Offset Loads, suspends Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems. When using the MRHS40781 I-Beam Hanger, structural steel must be run perpendicular to the Knight rail system.
Short Stack I-Beam Hanger (Perpendicular to I-Beam) (2in-7in Flange)
Used for Direct or Offset Loads, suspends Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems. When using the MRHS40771 I-Beam Hanger, structural steel must be run perpendicular to the Knight rail system.
Extended Stack I-Beam Hanger (7in-11in Flange)
Used for Offset and Direct Loads and suspends Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems. When using the MRHS42181 Hanger, structural steel can be run perpendicular or parallel to the Knight rail system.
This hanger is no longer stocked and has been superseded by MRHS42182.
V-Sway Brace (7in-11in Flange)
The MRWS41431 V-Sway Brace stabilizes Knight’s RAD4110, RAD6110, or RAD7510 Series Aluminum Rail Systems.