The EMRTA6196 Conductor Trolley travels inside of the red ERail and carries power to the electrical tools/fixtures on the rail system. It is combined with the Knight Load Trolley. Copper graphite shoes are used for energy and control voltages over 35 V.
The ERail Conductor Trolley comes with a protective cord clamp (EMRMA6172) to help prevent damage to the electrical cable. Cable available

Used for Direct Loads and suspends Knight’s ERAD4000, ERAD6000 or ERAD7000 Series Rail Systems. This hanger is for the non-electrified side of an ERail System.

When using the EMRHS6163 Hanger, structural steel can be run perpendicular or parallel to the Knight rail system.

Coated with an environmentally friendly corrosion protectant.

Used for Direct or Offset Loads and suspends Knight’s ERAD4000, ERAD6000 or ERAD7000 Rail Systems. When using the EMRHA6160 Hanger, structural steel can be run perpendicular or parallel to the Knight rail system.

The EMRAA6183 Power Feed End Cap Assembly attaches to the end of the ERAD6000 Rail and ERail. It is primarily used to prevent a load trolley from exiting the rail.

The EMRAA6182 End Cap Assembly attaches to the end of the ERAD6000 Rail and ERail. It is primarily used to prevent a load trolley from exiting the rail.

The EMRHS6262 Extending Stack I-Beam Hanger is used for Direct or Offset Loads and suspends Knight’s ERAD6000 Series Aluminum Rail Systems and ERail. When using the EMRHS6262 Hanger, structural steel can be run perpendicular or parallel to the Knight rail system.

The EMRES6185 Low Profile Rotating End Truck suspends Knight’s ERAD6000 Series Rail and the ERail. The end truck’s yoke design allows for the pivoting in the “X” and “Y” directions which creates freedom of movement.

EMRES6185-4000 runs inside of the RAD4110 Series Rail.
EMRES6185-6000 runs inside of the RAD6110 Series Rail.
EMRES6185-7000 runs inside of the RAD7510 Series Rail.

Knight’s Rotating End Truck for ERAD6000 suspends Knight’s ERail and ERAD6000 Rail. The End Truck’s Yoke design allows for the pivoting in the “X” and “Y” directions which creates freedom of movement.

EMRES6181-4000 runs inside of the RAD4110 Series Rail.
EMRES6181-6000 runs inside of the RAD6110 Series Rail.
EMRES6181-7000 runs inside of the RAD7510 Series Rail.

The EMRTA6192 Load Trolley with Yoke travels along a horizontal axis and suspends loads from the ERAD6000 Series rail system. The trolley’s yoke design allows for pivoting in the “X” and “Y” directions which creates freedom of movement. It attaches to the ERail’s conductor trolley.

Knight’s EMRTA6194 Low Profile Load Trolley suspends a load from the ERAD6000 Series Rail System.  It attaches to the ERail’s conductor trolley.