The KCA1040 Electrical Coil cable provides a robust method of communicating from the OCI (Operator Control Interface) module on the floor level, to the servo controls up on the rail. The coil cable is made up of a high resistant PVC and has proved the test of time. The four inch coil connects the In-Line Handle or (LMM) Load Monitoring Module in a

Knight KSHVA Overhead Carriage Mounted and KSHVAA Floor Mounted Vertical Servo Arms are Intelligent Assist Devices (IAD) that enable an operator to reach outside the area directly below a rail system and to precisely locate or float loads in the “Z” direction (vertical axis) with speed and reliability. The Vertical Servo Arms allow for a non-linear overhead varied reach within a

The EBA1293 Load Trolley with Brake transfers loads along the horizontal axis and suspends Knight Servo Hoists from Knight’s RAD7510 Series Rail Systems. The EBA1293 is typically used when an operator needs to lock or park a servo hoist from moving in a bridge or runway. This pneumatic brake feature allows for accurate loading and unloading of products.

The KSAA1050 Load Trolley transfers loads along the horizontal axis and suspends Knight Servo Hoists from Knight’s RAD7510 series rail systems.
(Previously EBA1030)

The KSAA1059 Servo Load Trolley transfers loads along the horizontal axis and suspends Knight Servo Hoists from Knight’s RAD6110 series rail systems.
(Previously EBA1173)

The KSAA1048 Servo Load Trolley transfers loads along the horizontal axis and suspends Knight Servo Hoists from Knight’s RAD4110 series rail systems.
(Previously EBA1020)

Bolt-on design that attaches to the servo hoists load trolley. The KSAA1011 Rail Brake is typically used when the operator needs to lock the servo hoist from moving in the bridge or runway rail. The locking feature allows the operator to accurately load and unload parts. The KSAA1011 servo hoist parking brake is also designed to be used as a drag brake, but

The KSAA1007 secures fixtures and loads in-line with the Servo System chain. This Shackle is designed with a larger connection opening to accommodate for Knight’s KSAA1007 Swivel Hook width. The KSAA1007 Swivel Hook Shackle is normally attached below the load cell handle and is used primarily for Knight’s In-Line Handle applications.

Shackle is normally attached below the load cell handle and used primarily for

Secures fixtures and loads in-line with the Servo System chain. The KSAA1004 Shackle is normally attached below the load cell. Knight’s Shackle features a female clevis for direct connections. The KSAA1004 Shackles are constructed of 4140 steel, and heat treated to Rock “C” 38-42. They have (2) two M6 steel dowel pins to capture, verses threaded rod and a M5 cross hole with

The KSAA1001 and KSAA1002 Quick Connect/Disconnects allow for fast connections and disconnections of fixtures and end effectors. The Quick Connect/ Disconnect easily disengages by the simple pull of a release pin. Each quick disconnect comes with two pins, and can be quickly connected to the servo inline handle.

KSAA1001 : 16mm to 7/8 in. adapter
KSAA1002 : 20mm